Add Apex Reservoir Graphic

The following is a guide to trick your Neptune Systems Apex into thinking that a DOS Dual Reservoir (DDR) is connected to your Apex.

Materials Required

• Male Micro Molex Plug with terminal sockets

• 150 Ohm Resistor

• Crimper (or soldering iron & solder)

• Electrical tape

Directions

1. Crimp or solder 150 Ohm resistor to female terminal sockets. I used a soldering iron.

2. Push terminals into the back of the top first and third connector holes (see second Image). You may need to use a small flathead screwdriver or similar tool to push the pins all the way into the connector.

3. Cover exposed resistor and wire with electrical tape.

4. Plug connector into the back of the Apex DOS.

5. A message should be displayed in Apex Fusion that says a new tile is available within a couple of minutes. Drag the new tile to your dashboard.

Disclaimer: The author makes no representation or warranties with respect to the accuracy, applicability, fitness, or completeness of the contents of this blog. The information contained herein is strictly for educational purposes. In no event shall we be held liable for any and all damages resulting from actions taken based on information in this blog.